-Rcexl Ignition Hall Sensor Test Kit Timing Device Universal Gas Engine Kits

Universal sensor tester is necessary, must use the protractor on your hand and according to the product specifications of the engine inlet angle correction. This product is applicable to the ignition Rcexl Aseel, unidirectional sensor output (3 pin connector) for most single / double cylinder 2 and 4 stroke engines. Two way sensor output (4 pin connector) is used in the multi cylinder 2 or 4 stroke engine, does not support the double cylinder, V type and star engine.
Scope of application:
1, the tester can detect any sensor using the Holzer element.
2, as a standard test, it can provide a lot of RC model engine to check whether the sensor is damaged.
3, you can check the sensor installation location.
4, you can check the correct installation of the direction of the magnet, so that the engine is easy to make the modification.
5, the tester has prompted acousto-optic display synchronization.
Note:
The setting method of unidirectional and bidirectional sensors is different.

1, connected to the power supply, the need for 4.8V-6.6V battery. The middle of the joint is positive, and the outside is negative;
3, 2 pin connector settings: the 3 pin connector of the detector is connected with the sensor's 3 pin connector; when the detector magnet of the Antarctic touches the sensor, the green indicator light and buzzer will ring. When the trailing edge of the magnet is connected to the sensor for the first time, the green indicating lamp and the buzzer are turned into an open state, and the state of the magnet is continuously changed into a closed state after the magnet is no longer in contact with the sensor. At this time need to set the angle, usually 30 degrees BTDC. But there are also some engines will be different, please according to the specification of your product specification set into the corner.
4, 3 pin connector settings: compared with the 3 pin connector, 4 pin connector more than one step in the Arctic settings. The north pole and the south pole are set at different points: 1) the south pole is a green indicator, while the north pole is the red indicator has a change; 2) the Arctic setting does not need to enter the angle of the setting unless there are special requirements.